| Subject | Text |
| k,
Can't really compare to computers. But it is definitley outdated in todays technology. A 25 mh |
| Horiz output | Ahh I get it now,
I would like to scope the base signal while lamp load is on and measure frequency |
|
|
| Toshiba TV 14R21 (PWB-1386 Board) keeps power on and off | I have a 14R21 Toshiba old TV and still not consider it as a junk. The problem now was after few min |
| If Radio / CD, etc. ALL work ... Your receiver is fine.
To confirm, take one of your working inputs |
| MC13306T3 = TA8205 | Hi again...
Panasonic (Matsushita) claim which MC13306T3 (Dual power output IC for car audio) can |
| My Tv is at the service and repairs (small local place) and they have contacted aking for any circui |
| Re: Ilo 32 quick inverter question... | [quote:2227ac3c45="teamitr"]Not familiar with the specifics of the set but, for the balast-on line, |
| Onida candy tv | Dear members,
I have Onida TV candy model 20 inches. It was working well. suddenly no power. I ch |
| This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after pay |
| [quote:0c9202a23f="ronw_57"]Hook up was with composite cables to get high def picture.[/quote:0c9202 |
| Zenith ZB4683RK convergence problem | Hello, If you look at the pics at
http://webpages.charter.net/jenglish_tnx/
you will see what I s |
| re; rca dead | Hi Guys, the power supply has failed in your set(s) without the
model & chassis number how do y |
| Does this tool exist??? (for potentiometer nut) | I am looking to find a tool (if one exists) to remove the fastener pictured in the photo below. I be |
| Re: Sony KV-21GMR1 | [quote:369e5e012c="marlon"]my Sony KV-21GMR1 is shutting down when u turn it on...you have to turn i |
| Interior telephone failure in 20 year old house | Hi, My phones are dead. There is white noice. I have unplugged all phones at the wall and then plugg |
| Have you disconnected the Y and X and no change? Have you disconnected the bottom buffer boards or t |
| Cheap a@@ computer. The VGA to HDMI will work if the video card supports it. The problem is there's |
|
|
| Plasma colours odd until it warms up | I have had what sounds like the same issue. I haven't had an LCD I couldn't repair yet, however I'm |
| Philips 28PW9623/05 MD2.25 | Hi
I've had the above tv for around 5 years with no problems except for a remote control that fo |
| Zenith CRT Board 9-1303-6 | [b:d740a652a9] Hello, anyone have the Pinout for the connectors
on the Zenith CRT Board 9-1303-6
|
| A two prong power plug means that the device is double insulated and either requires no earthing or |
| Might be close enough...
http://elektrotanya.com/?q=showresult&megnev=&megnev2=11AK49& |
| Thank you for your advice. I have reformed a lot of the solder joints on the HV board to check there |
| Looking For Service Manual for Conway PAL-1 Phone-a-lyzer | Hi. I am trying to troubleshoot a very nice piece of test equipment known as a PAL-1 Phone-a-lyzer m |
| File download | Sirs, I recently download circuit info for my Advance OS250 scope but only to find that its format i |
| Thanks,
I already have the service manual (see first post) what I need is a file (data / code) to p |
| Thank You Gest.
I am working on a Sony KP-51HW40 Projection TV.
When I power up the TV there are a |
| not that fault | hi i tried that but not fixed it, sometimes if i keep turning tv on and of and on and off it will co |
| Apple Service Diagnostic! URGENT!!! | I need Apple Hardware Diagnostic Collection for Apple G5 Dual Processor 1.8. Without it I can't cali |
| kenray is correct about most using a solder blob for ESD protection but, I believe your's is a dual |